Cw5000 Cw 5200 Small Laser Active Aqua Chilled Water System Water Chiller

Cw5000 Cw 5200 Small Laser Active Aqua Chill Chilled Water System Water Chiller

Product Description

Industrial water chiller is mainly suitable for plastic and mechanical processing. It can accurately control the temperature of plastic’s forming mold to shorten the molding cycle and speed up the product shaping; this series uses the principle of cold and heat exchange for cooling, which can be cooled quickly and the temperature control is stable. And not affected by environmental factors, it is an indispensable configuration equipment in modern industry.

Technical Parameters

Features

1. Using high quality computer board, the temperature is accurate to ±1℃.

2. Using Germany Schneider AC contactor and phase sequence relay.

3. Using ALCO filters.

4. Using American YK306F pressure controller.

Installation requirements

Choose a stable foundation for convenient installation and maintenance, it must be open surroundings, unobstructed, without corrosion, pollution, sun, rain. Choose a suitable cooling tower in accordance with the cooling capacity of the chiller. Install the piping of the chiller according to the size of the throat of the machine. Do not reduce the size of the cooling water pipe. This will cause high pressure overload, affecting the cooling effect and increase power consumption. The air-cooled chiller must be installed at a minimum distance of 1 meter against wall. For outdoor position, the rain-proof facilities must be provided.

Note: 1). The power load and grounding part should be constructed in accordance with relevant laws and regulations!

          2). The chilled water pipe of the newly installed chiller must be covered with an insulation layer!

Schematic Diagram of Air-cooled Chiller

1. compressor   2. High pressure meter   3. High voltage protector   4. Condenser   5. Cooling fan   6. Filter drier   7. Capillary (expansion valve)    8. Evaporato    9. Water pump    10. Low pressure meter    11. Low voltage protector    12-13. Waterway valve   

Frequently Asked Questions

 

1. When can you arrange shippment?
We usually arrange shippment within 15 days after getting deopsit, but customized machines should be more than 25 days.

2.Do you inspect the finished products?
Yes, each step of production products will be came out inspection by QC department before shipping.

3.Are you factory?
Yes, we are factory, all machine is made by ourself and we can provide customize service according to your requirement.

4.How to buy your Spot Welder?
Please send us inquiry to our email, and we will give you a PI to send us payment.