500 Liter Commercial Chilled Water Cooling System Industrial Water Chiller

500 Liter Commercial Chilled Water Cooling System Industrial Water Chiller Price

Product Description

Industrial water chiller is mainly suitable for plastic and mechanical processing. It can accurately control the temperature of plastic’s forming mold to shorten the molding cycle and speed up the product shaping; this series uses the principle of cold and heat exchange for cooling, which can be cooled quickly and the temperature control is stable. And not affected by environmental factors, it is an indispensable configuration equipment in modern industry.

Technical Parameters

Features

1. High efficiency foil aluminum fin condenser.

2. Tank coil evaporator (copper tube).

3. Using Stainless steel water tank.

4. Complete protection functions (phase loss, reverse phase, over temperature, high and low pressure, overload).

5. Using high quality computer board, the temperature is accurate to ±1℃.

6. Using Germany Schneider AC contactor and phase sequence relay.

7. Using ALCO filters.

8. Using American YK306F pressure controller.

Sequence of Operation

1). Turn on the power to the “ON” position;

2). Turn on the cooling switch. At this time, note that the cooling water inlet and outlet valve must be opened (Note: the air-cooled type does not need to be equipped with a cooling water tower).

3). Turn on the chilled water pump switch again. Please note that the inlet and outlet valves of the chilled water must be opened. The compressor will run automatically after the delay switch delays. Please check and adjust the required temperature.

4).Shut down in the reverse order.

Schematic Diagram of Water-cooled Chiller

1. compressor   2. High pressure meter   3. High voltage protector   4. Condenser   5. Filter drier   6. Capillary (expansion valve)   7. Evaporator    8. Chilled water pumps   9. Low pressure meter    10. Low voltage protector    11. Cooling water pump    12. cooling tower   13-14. Waterway valve   15-16. Waterway valv

Frequently Asked Questions

 

1. When can you arrange shippment?
We usually arrange shippment within 15 days after getting deopsit, but customized machines should be more than 25 days.

2.Do you inspect the finished products?
Yes, each step of production products will be came out inspection by QC department before shipping.

3.Are you factory?
Yes, we are factory, all machine is made by ourself and we can provide customize service according to your requirement.

4.How to buy your Spot Welder?
Please send us inquiry to our email, and we will give you a PI to send us payment.