1 Hp Chilled Water Cooler Cw5000 Industrial Water Chiller Water Cooled 2 3 Ton

1 Hp Chilled Water Cooler Cw5000 2 3 Ton Water Cooled Industrial Water Chiller

Product Description

Industrial water chiller is mainly suitable for plastic and mechanical processing. It can accurately control the temperature of plastic’s forming mold to shorten the molding cycle and speed up the product shaping; this series uses the principle of cold and heat exchange for cooling, which can be cooled quickly and the temperature control is stable. And not affected by environmental factors, it is an indispensable configuration equipment in modern industry.

Technical Parameters

Features

1. High efficiency foil aluminum fin condenser.

2. Tank coil evaporator (copper tube).

3. Using Stainless steel water tank.

4. Complete protection functions (phase loss, reverse phase, over temperature, high and low pressure, overload).

5. Using high quality computer board, the temperature is accurate to ±1℃.

6. Using Germany Schneider AC contactor and phase sequence relay.

7. Using ALCO filters.

8. Using American YK306F pressure controller.

Solutions for Poor Heat Dissipation

When the condenser heat dissipation is poor, the compressor efficiency is low and the operating current increases. When the air-cooled high-pressure rises to 24kg/cm2, or the water-cooled high-pressure rises to 20kg/cm2, the compressor trips under the protection of the high-pressure switch, and stops running. Upon poor heat dissipation, high pressure overload and fault code or fault indication, please check whether the circulating water of the cooling tower is normal, whether the cooling water temperature is too high, whether the cooling tower fan pump is running, and whether the cooling water valve is fully opened (please check for air-cooled type) Whether the radiator is dirty or blocked, after the above is normal, press the reset button (REST) or shut down and restart to operate normally. If high pressure overload occurs frequently, please arrange to clean the condenser as soon as possible.

Installation Diagram of Air-cooled Chiller

Frequently Asked Questions

 

1. When can you arrange shippment?
We usually arrange shippment within 15 days after getting deopsit, but customized machines should be more than 25 days.

2.Do you inspect the finished products?
Yes, each step of production products will be came out inspection by QC department before shipping.

3.Are you factory?
Yes, we are factory, all machine is made by ourself and we can provide customize service according to your requirement.

4.How to buy your Spot Welder?
Please send us inquiry to our email, and we will give you a PI to send us payment.