Cw3000 Cw 5000 Cw 5200 Industrial Water Chiller Air Cooled 1 Hp

Cw3000 Cheap Cw 5000 Cw 5200 1 Hp Industrial Cw 5200 Air Cooled Water Chiller

Product Description

Industrial water chiller is mainly suitable for plastic and mechanical processing. It can accurately control the temperature of plastic’s forming mold to shorten the molding cycle and speed up the product shaping; this series uses the principle of cold and heat exchange for cooling, which can be cooled quickly and the temperature control is stable. And not affected by environmental factors, it is an indispensable configuration equipment in modern industry.

Technical Parameters

Features

1. High efficiency foil aluminum fin condenser.

2. Tank coil evaporator (copper tube).

3. Using Stainless steel water tank.

4. Complete protection functions (phase loss, reverse phase, over temperature, high and low pressure, overload).

5. Using high quality computer board, the temperature is accurate to ±1℃.

6. Using Germany Schneider AC contactor and phase sequence relay.

7. Using ALCO filters.

8. Using American YK306F pressure controller.

Is the High and Low Pressure Normal?

When the water-cooled compressor is in normal operation, the high pressure display of 12～15kg/cm2 is the best, (the air-cooled 13～17kg/cm2 is the best) but not higher than 20kg/cm2, when the water-cooled pressure is higher than 20kg /cm2, or the air-cooled pressure is higher than 24kg/cm2, please refer to Note (1) for high-pressure switch tripping. For low pressure, 2.5～4.5kg/cm2 is the best, but not less than 2kg/cm2. For 2kg/cm2 low pressure trip, please refer to Note (2) for handling.

When the difference between the high pressure and the low pressure is very small or equal based on the running state of the compressor, it means that the valve of the compressor is damaged or broken. Please stop the operation immediately and notify the distributor or manufacturer.

Installation Diagram of Air-cooled Chiller

Frequently Asked Questions

 

1. When can you arrange shippment?
We usually arrange shippment within 15 days after getting deopsit, but customized machines should be more than 25 days.

2.Do you inspect the finished products?
Yes, each step of production products will be came out inspection by QC department before shipping.

3.Are you factory?
Yes, we are factory, all machine is made by ourself and we can provide customize service according to your requirement.

4.How to buy your Spot Welder?
Please send us inquiry to our email, and we will give you a PI to send us payment.