1 Ton Recirculating Active Aqua Inline Cw 5000 Mini Cw3000 Water Cooled Chiller

1 Ton Recirculating Active Aqua Inline Cw 5000 Mini Cw3000 Water Cooled Chiller

Product Description

Industrial water chiller is mainly suitable for plastic and mechanical processing. It can accurately control the temperature of plastic’s forming mold to shorten the molding cycle and speed up the product shaping; this series uses the principle of cold and heat exchange for cooling, which can be cooled quickly and the temperature control is stable. And not affected by environmental factors, it is an indispensable configuration equipment in modern industry.

Technical Parameters

Features

1. High efficiency foil aluminum fin condenser.

2. Tank coil evaporator (copper tube).

3. Using Stainless steel water tank.

4. Complete protection functions (phase loss, reverse phase, over temperature, high and low pressure, overload).

5. Using high quality computer board, the temperature is accurate to ±1℃.

6. Using Germany Schneider AC contactor and phase sequence relay.

7. Using ALCO filters.

8. Using American YK306F pressure controller.

Method of Operation

Before the trial run, make sure the following items are correct:

1). Fill the freezing water tank with water or other freezing medium before starting the water pump; (Note: Please choose the proper freezing medium as required)

2). Please pay attention to the running direction of the water pump and whether the water tower fan is reversed (if the water pump is three-phase, any two of the power phase lines must be exchanged for reversal, and then the switch should be closed after the connection is completed).

Schematic Diagram of Water-cooled Chiller

1. compressor   2. High pressure meter   3. High voltage protector   4. Condenser   5. Filter drier   6. Capillary (expansion valve)   7. Evaporator    8. Chilled water pumps   9. Low pressure meter    10. Low voltage protector    11. Cooling water pump    12. cooling tower   13-14. Waterway valve   15-16. Waterway valv

Frequently Asked Questions

 

1. When can you arrange shippment?
We usually arrange shippment within 15 days after getting deopsit, but customized machines should be more than 25 days.

2.Do you inspect the finished products?
Yes, each step of production products will be came out inspection by QC department before shipping.

3.Are you factory?
Yes, we are factory, all machine is made by ourself and we can provide customize service according to your requirement.

4.How to buy your Spot Welder?
Please send us inquiry to our email, and we will give you a PI to send us payment.